If you start photographing now, you’ll be surprised to discover the features available in your DSLR camera menu.While they all have a possible professional use to get quality results, it doesn’t take much experience to know how to use them., you don’t have to buy ultra-modern cameras, because these features are found in the most basic photographic equipment.With the ability to have full control of your camera, you can get perfect photos, worthy of the professionals who have been on the market for years.
The flash usually spoils a photograph that had everything to be good.And it’s bad, ever since? The accessory? It can be very useful when used correctly.The external flash, for example, provides too much light, giving it a very clear and colourless appearance.The advice to improve this aspect is to help compensate for flash exposure to reduce this glare.. To get started, set it to -2.This setting creates a smooth fill quality for the flash that is immediately more enjoyable.If you need even less light, you can reduce the flash to -3.Although this is rarely necessary, it can even add more intensity to your flash, increasing this number to positive.Remember: the correct use of the flash is to smooth the image and not remove shadows.
- This little-used feature can open up a whole new world of creative possibilities.
- It is usually located in the “Drive” menu.
- Your camera.
- If you are in a place where tripods are not allowed.
- It is still possible to take sharp photos even with prolonged exposure with these equipment.
- Select the two-second timer and place the camera on a chair or on the floor.
- When you pull the trigger.
- Your camera will move a little.
- But don’t worry.
- You still have two seconds left for the camera to stabilize and take the picture.
- This feature is also useful for tripods that are not as stable as they should be.
- If you do not have a remote trigger.
- This timer is an excellent alternative.
The histogram can be seen as a “glue” for photographing light tones.To make this really clear, you’ll need the chart on the right side to be as close to the histogram as possible.This parameter indicates a lighter exposure than a grayish when the exposure changes to allow more light to enter the sensor, the histogram will be directed to the right.Continue adjusting the settings until there is nothing left on the outside of the chart.This maximizes the full range dynamics your camera has the ability to have. When the chart data collides with the right side of the histogram, it technically left part of its scene overexposed. This means that there are no details in the fortresses, but an impossible access point to recover, even with sophisticated software.While this information is valuable, it doesn’t say exactly where the painful point is in your scene and that’s where the highlight alert feature comes in.
Most of the time, the camera’s default settings leave the highlight alert turned off, so you’ll need to turn it on in the menu.This tool shows you exactly which part of your image is overexposed, so you can correct it with an exposure setting, or even change the composition to eliminate this unwanted area.
By doing this, you guarantee more consistent exposures and avoid the bright areas in the photo.You can also save time on subsequent editing with preventive actions in the field.